SONAX Scratch Remover Paint Action Set

-Scratch Remover Paint Action Set
-Economical manual removal
-Removal of local scratches, scuffs or traces of paint from clear lacquer
-For all coloured & metallic as well as scratch-resistant paints

9,99 €

incl. 19% VAT , plus

Choose tax zone / country of delivery

Available immediately
Delivery time: 1 - 3 Workdays (DE - int. shipments may differ)

SKU: 20033151
GTIN: 4064700305847
HAN: 03058410
Category: Car care sets
Manufacturers: Sonax

Description
Sicherheitshinweise

Set for inexpensive manual removal of local scratches, scuffs or traces of paint from clear lacquer. Even deep scratches can be removed in just a few steps, provided they do not extend to the basecoat or primer. For all coloured & metallic as well as scratch-resistant paints. CONTENTS: 25 ml Polish 1, 25 ml Finish 2, 4 sanding sheets, 2 polishing fleeces and 1 polishing stamp.

At a glance:
-Manual removal of local scratches, scuffs or traces of paint from clear lacquer.
-Even deep scratches can be removed in just a few steps
-For all coloured & metallic as well as scratch-resistant paints

Application:

1.Before starting, wash the surface to be treated with gloss shampoo.

2.SANDING: Depending on the depth of the scratch, sanding may be necessary. To do this, stick one of the enclosed sanding pads under the polishing pad, moisten the lacquer with water and sand in circles over the scratch with light pressure. Do not sand all the way through to the primer and do not cant! Then wipe off any sanding residue with the enclosed polishing fleece. A matt area remains. ATTENTION: Sanding is only necessary for deep scratches. Many scratches and scuffs can be repaired without this step.

3.PRE-POLISHING: Apply Polish 1 to the scratched or already sanded area. Wrap the polishing pad with a clean polishing fleece. Then polish the scratched area with high pressure until the scratches or traces of grinding are no longer visible. Depending on the density and depth of the scratches, this may take several minutes. If the polishing area becomes too dry, apply Polish 1 again. Then wipe off polishing residues with polishing fleece.

FINISH: Apply Finish 2 to the previously polished area. Wrap a new clean spot of polishing fleece (as described before) around the polishing pad and rub with medium pressure until the desired surface shine is achieved. Finally, wipe off any residue with polishing fleece.

Instructions:
-Do not use in the sun or on hot rims.
-Do not allow to dry
-Protect product from frost

PDF