pH Neutral Snow Foam -Front Label
-Produces thick and clingy foam
-Safe on all surfaces and finishes
-Will not strip waxes or protective coatings
-pH neutral formula
-Good value for money
pH Neutral Snow Foam is designed to clean protected paint surfaces and remove dirt prior to shampooing, not the protective finish. You can apply this product via a pump sprayer (low foam) or via a foam lance (high foam). pH Neutral Snow Foam can be used to remove road traffic film safely and effectively without fear of damage to expensive and sensitive super and custom car finishes.
pH Neutral Snow Foam -Back label
Foam lance method - (for cars waxed or sealed with long lasting finishes) put 300ml into 1L foam lance bottle and 700ml water. Adjust the feed rate to suit the level of foam required for the job at hand. Foam entire car including wheel arches and wheels. Allow to dwell for 5 minutes then rinse off thoroughly.
Pump spray method
- provides concentrated cleaning power for unwaxed cars. If heavily soiled dilute 1:15, lightly soiled cars dilute 1:20. Spray lower area of the car, wheel arches and any area where dirt and grit has built up. Allow to dwell for 5 minutes then rinse thoroughly with a pressure washer. To remove bug splats dilute 1:5 and spray affected area prior to rinsing thoroughly with a pressure washer.
Note - this product freezes when stored below 5º C. If this happens bring product temperature up by either bringing it inside for several hours or place container in a hot bucket of water. This will not affect the product or its performance.
Observe common sense precautions when handling chemicals. In cases of contact with eyes rinse immediately with plenty of water. After use rinse hand thoroughly.
KEEP OUT OF REACH OF CHILDREN
May produce an allergic reaction
Warnhinweise gemäß CLP Verordnung
Keine Gefahrenhinweise vorhanden!